Posted: Mon May 07, 2007 9:29 am Post subject: R4FXO-ec R4FXO-EX stops working after upgrade!
If you have a R4FXO-EX or R4FXO-EC and have upgraded to the RPM version of our drivers or if you use our new driver method and your card stops working you may need to upgrade your hardware.
Reload your RCBFX driver and check your versions.
Code:
rmmod rcbfx
modprobe rcbfx
dmesg | grep rcbfx
You should see in the dmesg output something like:
Code:
rcbfx : Firmware Version 1.8
rcbfx : Hardware version 11
rcbfx : G168 DSP Ping DSP Version 106
If your Hardware version is 11 you are good, otherwise you need to upgrade.
To upgrade:
ssh in to the affected box.
Do the following:
Code:
cd /usr/src
wget ftp://ftp.rhinoequipment.com/RCBFX/Drivers/1.04b/rcb4fxo_11.tbz2
tar -xjvf rcb4fxo_11.tbz2
./rcb4fxo_11
init 0
After you init 0 power the box off for 30 seconds then bring it back up. Please note `reboot` or `init 6` will not work with this process. Also do not power your machine off durring the upgrade process as this may damage your hardware..
You can post new topics in this forum You can reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
